escription
MSN comes in 15, 20 meters roll. It should be stored in a shaded area away from chemicals and sharp edges. MSN is completely non- hazardous and non-inflammable, but however care should be taken while cutting and welding the joints. Hydrogen Chloride vapour will be released during the hot welding and therefore the joint area should be properly ventilated.
Uses
- Cut both ends to be welded straight using sharp knife (Jig)
- The ends are heated with welding equipment by pushing both ends of waterstop against blade.
- Maintain contact until melt into bead (approximate 1 minut)
- Release Jig and remove knife.
- Molten ends of waterstops are pushed together and allowed to cool for approximate 3 minutes. Release Jig and remove waterstop
- Inspect welded joint for continuity of weld and correct alignment of profiles.
المراجعات
لا توجد مراجعات بعد.